Appendix a: command generator command descriptions, A.1 hci link control commands, A.1.1 accept_connection_request – Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual User Manual
Page 87: A.1.2 add_sco_connection, A.1.3 authentication_requested, Appendix a command generator command descriptions, Hci link control commands, A: c, Ppendix, Ommand
69
CATC BTT
RAINER
2.20
A
PPENDIX
A
User’s Manual
A
PPENDIX
A: C
OMMAND
G
ENERATOR
C
OMMAND
D
ESCRIPTIONS
Note: “N/A” means Not Applicable. This indicates that the specified command does not have a parameter.
A.1 HCI Link Control Commands
A.1.1 Accept_Connection_Request
Used to accept a new incoming connection request. Execute this command before
connection request from another device. By default, all connection requests are accepted.
A.1.2 Add_SCO_Connection
Will cause the link manager to create an SCO connection in addition to the existing ACL
connection.
A.1.3 Authentication_Requested
Used to initiate authentication between the two devices associated with the specified
HCI_Handle.
Command Parameters
Examples
Comments
N/A
Return Events
Accept_Connection_Request_Complete
Command Parameters
Examples
Comments
HCI_Handle
0x0001
Packet Type
0x0080
Possible packet types:
HV1=0x0020
HV2=0x0040
HV3=0x0080
Return Events
Add_SCO_Connection_Complete
Add_SCO_Connection_Error
Command Parameters
Examples
Comments
HCI_Handle
0x0001