Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 41)

23
CATC BTT RAINER 2.20 C HAPTER 4
User’s Manual Profile Wizard
You can now refer to the section that describes the setup for the particular
profile that the target device uses:
• Section 4.2.1, “Connect to Device: Dial-Up Gateway” on page 23
• Section 4.2.2, “Connect to Device: Fax Gateway” on page 24
• Section 4.2.3, “Connect to Device: File Transfer” on page 25
• Section 4.2.4, “Connect to Device: HCRP Server” on page 26
• Section 4.2.5, “Connect to Device: Headset” on page 26
• Section 4.2.6, “Connect to Device: Headset Audio Gateway” on page 27
• Section 4.2.7, “Connect to Device: LAN” on page 28
• Section 4.2.8, “Connect to Device: Object Push” on page 28
• Section 4.2.9, “Connect to Device: PAN–GN” on page 29
• Section 4.2.10, “Connect to Device: PAN–NAP” on page 30
• Section 4.2.11, “Connect to Device: Serial Port” on page 31
4.2.1 Connect to Device: Dial-Up Gateway
Follow these steps to configure BTTrainer to connect to a Bluetooth device that uses the
Dial-Up Gateway profile.
Note: To connect to a device that uses the Dial-Up Gateway profile, you must install the virtual COM port
driver that is included with the BTTrainer installation. For instructions, see “Installing the Virtual COM
Port Driver” on page 39.
Step 1
Complete steps 1-6 in Section 4.2, “Connecting to Devices” on page 21.
Step 2
Select Dial-up Gateway from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
BTTrainer to switch roles during the connection.
Step 3
Click Next.
BTTrainer will establish a connection to the specified device.
Step 4
You can now send individual commands to the Dial-Up Gateway device via
the Profile Wizard interface or send data by using an external communication
application.
To send individual commands:
Use the Command combo box to manually enter a command or select one
from the drop-down list. You can also select a command from the Command
List and click Add in order to append the command to the current selection
in the combo box.
Press Send Cmd. The selected command will be sent to the remote device.
Each new command or combination of commands that you send during the
current session will be added to the drop-down list in the Command combo
box.