A.7.22 catc_set_broadcast_scan_window, A.7.23 catc_set_default_pin_code, A.7.24 catc_set_park_mode – Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual User Manual
Page 125
107
CATC BTT
RAINER
2.20
A
PPENDIX
A
User’s Manual
A.7.22 CATC_Set_Broadcast_Scan_Window
This command will send LMP_Set_Broadcast_Scan_Window PDU to the parked devices to
set a new BroadcastScanWindow.
A.7.23 CATC_Set_Default_PIN_Code
Set the default PIN code, used for authentication purposes whenever a device-specific PIN
is unavailable.
A.7.24 CATC_Set_Park_Mode
This command sets firmware mode that defines whether to park a device by PM_ADDR or
by BD_ADDR when HCI_Park_Mode command is received. The default mode is parking
by PM_ADDR. The command can be called at any time to specify which mode to use for
parking devices. It will allow the selection of how individual devices will be parked.
Used in Test Cases
Command Parameters
Examples
Comments
HCI_Handle
BroadcastScanWindow
Integer
Return Events
Generated Event: Command Status
Generated Event: Command Complete
Command Parameters
Examples
Comments
PIN_Code
Command Parameters
Examples
Comments
ParkMode
0 (default) - parking by PM_ADDR
1 - parking by BD_ADDR
2-0xFF - reserved
Return Events
Command Complete: Will return after the operation has completed.
Test Case
Description
TP/LIH/BV-22-C
Need to park slave device using PM_ADDR=0