Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 54)

36
CATC BTT RAINER 2.20 C HAPTER 4
User’s Manual Profile Wizard
Note: The Speaker and Microphone Volume levels shown in the previous
screenshot reflect the volume settings on the Master device. If you adjust the
levels on the remote device, the displayed volume levels will change
accordingly.
Step 2
Direct a remote Bluetooth device to connect to BTTrainer.
Once the connection is established, the Emulation Status screen will indicate
that BTTrainer has an RFCOMM connection to the device.
Step 3
Click the Answer button to make an SCO connection with the remote
device.
If the connection attempt is succesful, the screen will change to indicate that
an SCO connection has been established.
Step 4 (Optional) Click the Hang Up button to close the connection. The
connection between BTTrainer and the device will terminate.
4.3.6 Emulate Device: Headset Audio Gateway
BTTrainer can be configured to emulate a wireless device that conforms to the Bluetooth
Headset Audio Gateway profile. The following steps show how to set up BTTrainer as a
Headset Audio Gateway device and connect to it with a remote Bluetooth headset.
Step 1 Complete Steps 1-4 in Section 4.3, “Emulating Devices” on page 32.
The Headset AG Emulation screen will open, indicating that BTTrainer has
been configured to emulate a device that supports the Headset Audio
Gateway profile and is awaiting connection from a device.
Note: The Speaker and Microphone Volume levels shown in the previous
screenshot reflect the volume settings on the Master device. If you adjust the
levels on the remote device, the displayed volume levels will change
accordingly.
Step 2
Direct a remote Bluetooth device to connect to BTTrainer.
Once the connection is established, the Emulation Status screen will indicate
that BTTrainer is currently connected to the device.
Step 3 To verify that BTTrainer and the remote device are successfully connected,
speak into the microphone on one device and listen for audio on the other.
4.3.7 Emulate Device: LAN
Step 1
Complete Steps 1-4 in Section 4.3, “Emulating Devices” on page 32.
Step 2 In the Emulate Device dialog, select LAN.
The LAN screen will open, indicating that BTTrainer has been configured to
emulate a device that supports the LAN profile and is awaiting connection
from a device.