Nortel Networks NN43001-563 - Manual (Page 475)

Install the DCHIP hardware upgrade kit 475
4 Connect the NTCW84EA pigtail cable from port 0 of the DCHIP PC
Card to the J14 pin header on the motherboard of the DCHIP card
(see
Figure 34 "DCHIP PC Card and NTCW84EA pigtail cable" (page
193) ). The cable routes the D-Channel signals to the backplane and
the I/O panel. The PC Card connector is keyed to allow insertion
only in the correct direction. The J14 pin header connector is not
keyed. Be careful to align the connector with the pin header.
Figure 156
DCHIP PC Card and NTCW84EA pigtail cable
5 Pull the top and bottom locking devices away from the trunk card
faceplate. Insert the trunk card into the card slots and carefully
push it until it makes contact with the backplane connector. Hook
the locking devices.
—End—
Install the DCHIP I/O Panel breakout cable from the upgrade kit
The breakout cable provides one D-channel connector.
If installing the DCHIP upgrade kit for the NTCW80AA ITG 8-port trunk card,
use the NTCW84MA I/O Panel breakout cable.
If installing the DCHIP upgrade kit for the NTCW80CA ITG 8-port trunk
card, use the NTCW84LA I/O Panel breakout cable.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.