Nortel Networks NN43001-563 - Manual (Page 279)

Make test calls to the remote nodes (ITG Trunk or IP Trunk) 279
TM 3.1 Alarm Notification must be restarted whenever Control Files
are changed.
9 If TM 3.1 Alarm Notification is running (a red traffic light is showing
on the tool bar), stop it by clicking on the red traffic light on the tool
bar. Restart it by clicking on the green traffic light.
10 If TM 3.1 Alarm Notification is not running (a green traffic light is
showing on the tool bar), start it by clicking on the green traffic light
to change it to red.
11 Enter the trap_gen command from the ITG shell. A series of
SNMP traps is emitted by the IP trunk card and appears in the TM
3.1 Alarm Notification browser window. Verify the device name
identifies the correct IP trunk card.
—End—
Make test calls to the remote nodes (ITG Trunk or IP Trunk)
Make test calls to ensure the following:
• The IP Trunk 3.01 (and later) system can process calls from each node
to a remote node.
• The IP trunk cards are enabled.
• QoS, as defined within the Dialing Plan window, is acceptable.
Check the IP Trunk 3.01 (and later) operational report. If fallback to PSTN
occurs, examine the IP data network for problems. Also, check the IP trunk
cards’ dialing plan table and verify that the remote ITG Trunk 2.x or IP Trunk
3.01 (and later) node is powered up, configured, and enabled.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.