Backup and restore from the cli, Procedure 67 backing up from the cli – Nortel Networks NN43001-563 User Manual

Page 380

380

OA and M using the ITG shell CLI and overlays

When the new software has downloaded into the flash ROM device,
reboot the IP trunk card to use it. Use the

cardReset

command or

press the reset button on the IP trunk card faceplate.

—End—

Backup and restore from the CLI

Use

and

to backup and restore when the

preferred method, using the TM 3.1 PC, is not available. This whole
procedure must be performed when a configuration file has been changed.

First, use the ’Put’ commands to back up the IP trunk card configuration
files. Restore the files later using the "Get" commands.

However, the "DPAddrTGet" file can be used to restore the dialing plan file
from another IP trunk card in the same node.

Backup from the CLI

Follow the steps in

to perform a backup from the CLI.

Procedure 67

Backing up from the CLI

Step

Action

Identify an appropriate FTP host and obtain the IP address, the user
name, the password, and a directory path on the host.

Use the

BootPFilePut

command with the appropriate parameters,

to backup the Node Properties file to the FTP host.

Use the

DPAddrPut

command with the appropriate parameters, to

backup the dialing plan file to the FTP host.

For each IP trunk card, log in to the ITG shell and use the

configFilePut

command to backup the card properties files.

Each file must be named to identify the card it goes with.

—End—

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007