Nortel Networks NN43001-563 User Manual

Page 264

264

Install and configure IP Trunk 3.01 (and later) node

Disable IP trunk cards whenever transmitting card properties or new
software.

Use the TM 3.1 Maintenance Windows, the TM 3.1 System Passthru
terminal, or a system management terminal directly connected to a TTY
port. Use the LD 32 DISI command to disable the IP trunk cards when idle.
In the TM 3.1 IP Telephony Gateway – ISDN IP Trunk window, select View >
Refresh and verify that the card status is showing "Disabled". If the card
status is showing "unequipped", configure the card in LD 14.

To transmit the node properties, card properties, and dialing plan to Leader
0, follow the steps in

Procedure 29 "Transmitting the node properties, card

properties and dialing plan to Leader 0" (page 264)

Procedure 29

Transmitting the node properties, card properties and dialing plan to Leader 0

Step

Action

From the TM 3.1 Navigator window, double-click the ITG ISDN IP
Trunks icon from the Services folder. The IP Telephony Gateway -
ISDN IP Trunk window opens.

Select the IP Trunk 3.01 (and later) node for which the properties are
to be transmitted from the list in the upper part of the window.

Select Leader 0 from the list in the lower part of the window.

In the IP Telephony Gateway - ISDN IP Trunk window, select menu
Configuration > Synchronize > Transmit.

Leave the radio button default setting of Transmit to selected
nodes. Check the Node Properties, Card Properties and Dialing
Plan check boxes.

Click the Start Transmit button.

Monitor progress in the Transmit Control window. Confirm that the
Node Properties, Card Properties and Dialing Plan are transmitted
successfully to the Leader 0 IP trunk card TN. At this point, it is
normal for transmission to Leader 1 and Follower cards to fail.

When the transmission is complete, click the Close button.

Reboot the Leader 0 IP trunk card.

—End—

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007