Nortel Networks NN43001-563 User Manual

Page 425

ITG-Pentium 24-port trunk card faceplate maintenance display codes

425

Normal
Code

Fault
Code

Description

T:18

F:18

Booting host, waiting for response with self-test
information

PT:0

PF:0

Pentium module suspend signal OK

PT:1

PF:1

Pentium module powered OK

If the displays this message, check that the Pentium
module is fully seated in the motherboard socket.

T:19

Waiting for application startup message from host

T:20

Card LAN enabled, waiting for Request Config
Message.

IP trunk card is looking for an active leader by sending
BOOTP requests on the ELAN subnet. If no BOOTP
response is received on the ELAN subnet, Leader 0
times out first and starts active leader tasks. Leader
1 has a longer time out and normally starts backup
leader tasks when it detects an active leader, otherwise
Leader 1 times out and starts active leader tasks.

A Follower card sends BOOTP requests on the
ELAN subnet continuously and never times out.
From the keyboard of a terminal attached to the
local maintenance port, enter +++ to escape from
BOOTP request mode and start ITG shell for manual
configuration.

BIOS

Card is running the ROM BIOS.

The card detected no valid IP Trunk 3.01 (and later)
software image or the JKL escape sequence was
entered during startup from the keyboard of a terminal
connected to the local maintenance port.

If the IP trunk card faceplate displays BIOS, it is not
functioning as an IP trunk card.

T:21

Card LAN operational, A07 interface to system
enabled, display now under IP Trunk 3.01 (and later)
software control.

ITG > shell is available for manual card configuration.

T:22

ITG-Pentium 24-port trunk card is starting up the IP
Trunk 3.01 (and later) application.

LDR

Card is running active leader tasks.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007