Nortel Networks NN43001-563 User Manual
Page 270
270
Install and configure IP Trunk 3.01 (and later) node
Enter new password again to confirm: new password
5
Record the new user name and password and transmit to authorized
network security personnel.
6
Repeat procedure for all cards in the node.
—End—
If the entire sequence of commands is successfully entered, the system
response
value = 0 = 0x0
is displayed. The new user name and
password are now stored in the non-volatile RAM on the IP trunk card and
are retained even if the card is reset, powered-off, or on.
To reset the ITG shell password to its default setting, see
ITG shell password" (page 370)
.
Change default ESN5 prefix for non-ESN5 IP telephony gateways
Follow the steps in
Procedure 34 "Changing the default ESN5 prefix for
non-ESN5 IP telephony gateways" (page 270)
to configure an ESN5 prefix
for the non-ESN5 IP telephony gateways by using the "esn5PrefixSet"
command from the ITG shell CLI. The default esn5 prefix (100) corresponds
to NCOS 00. If NCOS 00 does not allow access to all the required trunk
facilities, change the default ESN5 prefix to work with the established NCOS
plan in the customer’s network. Refer to
"ESN5 network signaling" (page
. Perform this procedure on every card in the node.
Procedure 34
Changing the default ESN5 prefix for non-ESN5 IP telephony gateways
Step
Action
1
Select the new IP Trunk 3.01 (and later) node in the upper part of
the IP Telephony Gateway - ISDN IP Trunk window.
2
For each IP trunk card in the node, right-click the IP trunk card and
select Telnet to ITG Card from the right-click menu.
The Telnet window appears with the VxWorks prompt.
3
When prompted to login, enter the default (or user-modified) login
and password.
VxWorks login:
itgadmin
Password:
itgadmin
ITG>
esn5PrefixShow
See
Figure 62 "esn5PrefixShow" (page 271)
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563
01.01
Standard
Release 5.0
30 May 2007
Copyright © 2007, Nortel Networks
.