Nortel Networks NN43001-563 User Manual

Page 226

226

Install and configure IP Trunk 3.01 (and later) node

Prompt

Response

Description

It might be necessary to configure partial IP trunk cards
due to WAN traffic capacity limitations, or Leader and
DCHIP card real-time capacity for very large nodes and
networks.

TYPE

TIE

XX XX

Terminal number

l s c u

Format for Large System, Call Server 1000E, and Media
Gateway 1000E, where l = loop, s = shelf, c = card, u = unit

c u

Format for Small System and Media Gateway 1000B
where c = card and u = unit

DES

16 character descriptive designator for the IP trunk card.

See Note 1

hhhh:hh:hh:hh:h
h

For unit 0. The IP trunk card ELAN network interface
MAC address.

xxx.xxx.xxx.xxx

For units 1 – 23. The IP trunk card ELAN network interface
IP address.

XTRK

Extended Trunk Type: IP trunk card (1-slot or 2-slot
assembly).

MC32

Single slot, 32-port StrongArm (SA) processor Media
Card.

MC24

Double slot, 24-port Pentium processor Media Card.

MAXU

Maximum number of ports on this IP trunk card,
where:

xx = 32 for the Media Card 32-port trunk card
xx = 24 for the ITG-Pentium 24-port trunk card

A warning message is printed if a number larger than 24
is entered for MAXU. Ignore this warning for the Media
Card 32-port trunk card.

CUST

Customer number as defined in LD 15.

RTMB

Route number and Member Number

0-511 1-4000

Range for Large System, Call Server 1000E, and Media
Gateway 1000E

0-127 1-4000

Range for Small System and Media Gateway 1000B.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007