Nortel Networks NN43001-563 User Manual

Page 252

252

Install and configure IP Trunk 3.01 (and later) node

the network. This procedure also can be used to create a dialing plan for a
new node in a very small network. If adding a new node to a large existing
network, it is more efficient to retrieve the IP Trunk 3.01 (and later) node
dialing plan from an existing node.

A dialing plan consists of a number of IP Trunk 3.01 (and later) destination
nodes and one or more dialing plan entries for each destination node. Select
a destination node, define the destination node protocol capability, decide if
QoS monitoring is to be enabled for this destination node, and enter one
or more ESN dialing plan entries for each destination node. Repeat this
procedure for all destination nodes in the IP Trunk 3.01 (and later) network.

The dialing plan information entered in TM 3.1 must match the ESN data
entered in the LD 15, LD 16, LD 86, LD 87 and LD 90. Keep the dialing plan
entries consistent between the Meridian 1/CS 1000M and the IP Trunk 3.01
(and later) node. Transmit the dialing plan from TM 3.1 to the IP Trunk 3.01
(and later) node during installation, card replacement, when IP Trunk 3.01
(and later) nodes are added to the network, or whenever the dialing plan
on TM 3.1 IP Trunk 3.01 (and later) is changed.

Each IP Trunk 3.01 (and later) trunk node shares one dialing plan for all
cards in the node. The IP Trunk 3.01 (and later) node dialing plan translates
the dialed digits in the system ISDN Signaling Call Setup message,
according to ESN translation type, into the Node IP addresses of the IP
Trunk 3.01 (and later) destination nodes.

Procedure 24

Configure the ITG Dialing Plan General tab

Step

Action

In the IP Telephony Gateway – ISDN IP Trunk window, select the
new IP Trunk 3.01 (and later) node for which a dialing plan is to be
built. Select menu Configuration > Node > Dialing Plan. The ITG
Dialing Plan window opens.

In the ITG Dialing Plan window, select the menu Configuration
> Add Remote Node. The ITG Dialing Plan – Remote Node
Properties window opens and displays the General tab. See

Figure

59 "ITG Dialing Plan Remote Node Properties window – General
tab" (page 253)

. The default Node drop-down list reads "Not defined

on this TM 3.1 PC" and the Node IP address field is blank. Click the
drop-down list to see a list of all the other IP Trunk 3.01 (and later)
nodes configured on this TM 3.1 PC. The IP Trunk 3.01 (and later)
node for which the dialing plan is being created is not seen.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007