Nortel Networks NN43001-563 - Manual (Page 325)

Define the dialing plan information 325
• If the destination is in the local TM 3.1 provisioning, select the
node from the Node drop-down list (on the far left of the screen).
• If the destination is not in the local TM 3.1 provisioning, enter
the information manually.
Destination node selection in local TM 3.1 provisioning
4 If the destination node is in the local TM 3.1 provisioning, select the
node from the Node drop-down list (on the far left of the screen).
In this example, as seen in Figure 116 "ITG Dialing Plan – Remote
Node Properties window – General tab" (page 323) , the destination
node is selected from the Node drop-down list from the local TM
3.1 provisioning. When a node is selected, the data specific to the
selected remote node is displayed on the General tab. See
Figure
119 "Selected Remote Node" (page 325) .
Figure 119
Selected Remote Node
5 Set the QoS parameter, if desired. Ensure that Fallback to the PBX
is in place if QoS levels are not maintained.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.