Backup and restore procedures, Ip trunk card, Tm 3.1 – Nortel Networks NN43001-563 User Manual
Page 418: Command line interface
418
Maintenance
Click the Start Transmit button.
The transmission status is displayed in the "Transmit control" box.
Confirm the card properties and dialing plan are transmitted correctly.
4
When the transmission is complete, click the Close button.
5
Use the LD 32 ENLC command to re-enable the IP trunk card.
6
In the IP Telephony Gateway main window, select menu View >
Refresh. The card status displays "Enabled."
7
Check the TN, ELAN network interface MAC address, and IP
addresses for each IP trunk card. Compare the displayed values with
those on the IP Trunk 3.01 (and later) Installation Summary Sheet.
8
Update the IP Trunk 3.01 (and later) Installation Summary Sheet
with the new MAC address of the replacement IP trunk card.
—End—
Backup and restore procedures
IP trunk card
Data configured on the TM 3.1 PC (for example, address translation tables
and DSP configuration) is locally saved on the TM 3.1 PC. The data is also
downloaded to the IP trunk cards. The IP trunk card stores this data in
its internal Flash File volume (Flash EPROM, which acts as a disk drive).
The TM 3.1 PC can query the card and retrieve data from it. If the IP trunk
card is replaced, the version of data stored on the TM 3.1 PC can be used
to configure the new IP trunk card with the same data as on the replaced
IP trunk card.
Log files, such as Alarm and Trace files, if any, are written to the Flash File
volume and not lost when the card fails. Operational Measurement files are
recorded hourly and need to be uploaded to the TM 3.1 PC or other external
device for generating weekly or monthly traffic reports.
TM 3.1
TM 3.1 has backup and restore procedures for all data downloaded from, or
to, the IP trunk card. When an TM 3.1 terminal is connected to the card,
user intervention is necessary to transmit all lost data from the TM 3.1
terminal to the IP trunk card.
Command Line Interface
If TM 3.1 is temporarily unavailable, the ITG shell CLI can be used to
retrieve configuration files from an FTP server or from a PC Card.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563
01.01
Standard
Release 5.0
30 May 2007
Copyright © 2007, Nortel Networks
.