Nortel Networks NN43001-563 - Manual (Page 242)

242 Install and configure IP Trunk 3.01 (and later) node
• 1 – 382 for the NTVQ90BA Media Card 32-port trunk card
The First CHID is the ISL Channel ID of Unit 0 on this IP trunk
card, as configured in LD 14 for the IP trunk cards and units.
Consecutive CHIDs are assigned to remaining units on the card
when configuring trunks in LD 14 using the
NEW xx command.
11 Click Add and then click Apply.
In most cases, do not click OK until all cards are added to the IP
Trunk 3.01 (and later) node and all configuration tasks completed.
If OK is clicked before completing configuration, TM 3.1 exits the
node property configuration session and displays the IP Telephony
Gateway – ISDN IP Trunk window. To complete the configuration
tasks, double-click the new IP Trunk 3.01 (and later) node in the list
in the upper part of the window.
12 Repeat steps 1 – 10 for Leader 1 and each Follower in the IP Trunk
3.01 (and later) node.
—End—
Configure DSP profiles for the IP Trunk 3.01 (and later) node
Follow the steps in Procedure 20 "Configuring DSP profiles for the IP Trunk
3.01 (and later) node" (page 242) to select a DSP profile, set Profile Options
and Codec Options and, if required, modify default DiffServ/TOS values
from 0. Set these profiles once for the IP Trunk 3.01 (and later) node. In a
later step, download the DSP profiles card properties to each card.
Procedure 20
Configuring DSP profiles for the IP Trunk 3.01 (and later) node
Step Action
1 Click the DSP Profile tab. See Figure 53 "DSP Profile – General
tab" (page 243) . The General tab displays a detailed description of
the default DSP Profile 1.
2 Change the default DSP profile from the drop-down list, if required.
There are three DSP profiles. Each profile contains two or more
codecs. All IP trunk cards in the same node share the same DSP
profile.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.