Nortel Networks NN43001-563 User Manual

Page 463

Install the RM356 modem router

463

Toggle "RIP Direction=None". Press Enter to confirm and save data
to ROM, then press Esc to return from the sub-menu to the main
menu.

Enter menu selection number 12, "Static Routing Setup", under the
"Advanced Applications" section.

"Menu 12 – Static Route Setup" sub-menu is displayed.

If firewall security is properly configured in the customer’s
Management Gateway router, and if the modem router is permitted
access over the TLAN subnet to other IP Trunk 3.01 (and later)
nodes on remote ELAN subnets, define a default network route
pointing to the Management Gateway IP address on the local ELAN
subnet. Alternatively, define up to four different static network routes
or host routes in the modem router to limit routing access from the
modem router to the TLAN subnet.

To prevent access from the modem router to the TLAN subnet
through the Management Gateway router on the ELAN subnet,
disable RIP by setting "RIP Direction=None", and remove all static
routes or disable a particular static route by setting "Active=No".

Enter menu selection number 1 to edit the first static route.

"Menu 12.1 – Edit IP Static Route" is displayed.

Type in a descriptive route name, for example, "DefaultGW" (no
spaces). Toggle "Active=Yes/No" for security purposes. The
destination IP address can be the default network route "0.0.0.0", or
a specific network or host route for greater security. The gateway
IP address is the Management Gateway IP address on the ELAN
subnet where the modem router is connected. Press Enter to
confirm and save data to ROM, then press Esc to return from the
sub-menu to the main menu.

Enter menu selection number 13, "Default Dial-in Setup", under the
"Advanced Applications" section.

"Menu 13 – Default Dial-in Setups" is displayed.

Under "Telco Options" toggle "CLIDAuthen=None/Preferred/Re-
quired".

CLID requires a CO line subscribed for CLID service where available.
"Preferred" means some dial-in user profiles might require CLID, but
others may not. "Required" means no dial-in call is connected unless
CLID is provided and user profiles require CLID for authentication.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007