Nortel Networks NN43001-563 - Manual (Page 396)

396 Maintenance
Command Function
ENLC l s c Enable the indicated IP trunk card, where:
l = loop, s = shelf, and c = card.
ENLU l s c u Enable the indicated unit, where:
l = loop, s = shelf, c = card, and u = unit.
LDIC l s c u List the number of days since the last incoming call
on the indicated trunk, where:
l = loop, s = shelf, c = card, and u = unit.
STAT l s c Print the system software status of the indicated IP
trunk card, where:
l = loop, s = shelf, and c = card.
RSET l s c u Reset thresholds for the indicated trunk, where:
l = loop, s = shelf, c = card, and u = unit.
For Meridian 1 PBX 11C Cabinet, Meridian 1 PBX 11C Chassis, CS 1000M Cabinet, and CS
1000M Chassis, the TN address < l s c > should be replaced by < s c > and the < l s c u > address
replaced by < s c u >.
Information equivalent to that provided by the STAT command can be
accessed from the command line on the card.
Identify IP Trunk 3.01 (and later) trunk routes and IP trunk cards
in the system
In LD 16, the Route Data Block, use the "DES" prompt to identify the IP
Telephony Gateway route.
IP trunk card ELAN network interface MAC address and IP
address
In LD 14, use the "DES" prompt to identify the ELAN network interface
MAC address and IP address.
Print the IP Trunk 3.01 (and later) trunk route and trunk
designators
In LD 21, enter the "LTM" (List Trunk Members) in response to the "REQ"
prompt to list the IP Trunk 3.01 (and later) route designator’s and the
individual IP Trunk 3.01 (and later) trunk designators’ MAC addresses
and IP addresses. When cards are added, deleted, or changed, the trunk
designators must be updated.
TM 3.1 maintenance commands
When changing DSP parameters in TM 3.1, disable the IP trunk card’s ports
before downloading the new parameters. Modifications to node parameters
require the affected cards to be rebooted. A dialing plan can be modified
without rebooting or disabling the cards.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.