Nortel Networks NN43001-563 User Manual

Page 267

Transmit IP trunk card configuration data from TM 3.1 to the IP trunk cards

267

Verify that the TN, ELAN network interface MAC addresses, and IP
addresses are configured correctly for each IP trunk card. Select
any card in the IP Trunk 3.01 (and later) node in the TM 3.1 ITG –
ISDN IP Trunk window and select menu Configuration > Node >
Properties from the drop-down lists. Compare the values displayed
on the General tab and the Card Configuration tab with those on
the IP Trunk 3.01 (and later) Installation Summary Sheet. The ITG –
Transmit Options dialog box appears.

Correct errors and retransmit Node Properties.

Reboot all cards for which Node Properties have changed.

—End—

Transmit card properties and dialing plan to Leader 1 and Follower cards

Verify that the IP trunk cards are disabled before transmitting card properties.

Note: Disable IP trunk cards when transmitting card properties or new
software.

Use the TM 3.1 Maintenance Windows, the TM 3.1 System Passthru
terminal, or use a system management terminal directly connected to a
TTY port on the system. Wait for the NPR0011 message, which indicates
that all units on each card are disabled.Use the LD 32 DISI command to
disable the IP trunk cards when idle. In the IP Telephony Gateway - ISDN
IP Trunk window, select View > Refresh and verify that the card status is
showing "Disabled". If the card status shows "unequipped", configure the
card in LD 14.

Follow the steps in

Procedure 31 "Transmit card properties and dialing plan

to Leader 1 and Follower cards" (page 267)

to transmit the card properties

and dialing plan to the Leader 1 and Follower IP trunk cards.

Procedure 31

Transmit card properties and dialing plan to Leader 1 and Follower cards

Step

Action

Select the IP Trunk 3.01 (and later) node for which properties are to
be transmitted from the list in the upper part of the window.

Select Leader 0 from the list in the lower part of the window.

In the IP Telephony Gateway - ISDN IP Trunk window, select
Configuration > Synchronize > Transmit.

Keep the radio button default setting of Transmit to selected nodes.
Check the Card Properties and Dialing plan check boxes.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007