Nortel Networks NN43001-563 - Manual (Page 214)

214 Install and configure IP Trunk 3.01 (and later) node
Figure 48
Option 11C DCHIP system cabling
NTWE04AC/AD SDI/DCH Meridian 1 Option 11C Cabinet/CS
1000M Cabinet extension cable
The NTWE04AC and the NTWE04AD are 10-ft and 1-ft DCHIP extension
cables, respectively. They connect Port 1 or Port 3 of the DCHIP SDI/DCH
cable used on the Meridian 1 Option 11C Cabinet/CS 1000M Cabinet
(NTAK19BA or equivalent) with the DCHIP NTMF29Bx face-plate cable.
NTAK19BA four-port SDI/DCH cable
The NTAK 19BA cable is an Option 11C MDF cable for interfacing to the
4-port NTAK02 SDI/DCH card.
Other components
For Large Systems, I/O panel 50-pin filtered adapters NTCW84JA are
required for 100BaseT TLAN subnet operation.
IP Trunk 3.01 (and later) uses the ITG Card ELAN/TLAN adapter to route
Ethernet signals through the system I/O panel and through system filtering.
For standard 10BaseT operation, this inherent filtering in the system does
not pose a functional concern.
For 100BaseT Ethernet links, the system filtering does impact functionality.
Special consideration has been given to the routing of the TLAN network
interface Tip and Ring pairs. On a Meridian 1, some of the Tip and Ring
pairs have been left free of filtering. The TLAN subnet has been routed on
the Media Card 32-port trunk card to take advantage of this. By default,
100BaseT operation is fully functional on Small Systems.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.