Nortel Networks NN43001-563 - Manual (Page 405)

ITG shell command set 405
Command Description
Example: ITG> DSPRcvLpbkTestOn
DSPRcvLpbkTestOff Stop Receive loopback test on the indicated DSP.
Example: ITG> DSPRcvLpbkTestOff
Table 65
Operational Measurement command
Command Description
resetOM This command returns all Operational Measurement
parameters collected since last log dump, including:
• outgoing calls tried
• outgoing calls completed
• incoming calls tried
• total voice time
• total fax time
• outgoing packets discarded
• incoming packets out–of–sequence
• average packet delay
• average packet loss
• number of Fallback-to-PSTN calls
Table 66
DCHIP-only commands
Command Description
DCHenable Enable the DCH application on the card.
DCHdisable Disable the DCH application on the card.
DCHestablish Establish the DCH link when it is in release mode.
DCHrelease Release the DCH link when it is in establish mode.
DCHstatus Display the DCH application state.
DCHmenu This command allows the user to access the UIPC Debug
Menu. Once in passthru mode, the user has to "exit" the Debug
Menu, before issuing any other ITG Shell Commands.
dchipResTableShow Available from ITG shell. Show the Followers associated with
a DCHIP.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.