Nortel Networks NN43001-563 User Manual

Page 222

222

Install and configure IP Trunk 3.01 (and later) node

Prompt

Response

Description

TKTP

Trunk type.

TIE

The trunk type for IP Trunk 3.01 (and later) trunks must
be set to TIE.

SAT

(NO) YES

Satellite control (SAT) must be set to NO to enable
Trunk Optimization before answer (TRO) and Trunk
Anti-Tromboning (TAT).

For IP Trunk 3.01 (and later), fallback to circuit-switched
trunks does not depend on SAT=YES.

...

DTRK

Digital trunk route.

(NO)

IP Trunk 3.01 (and later) trunks are analog only. They do
not support circuit-switched data from MCA or ISDN BRI
terminal adaptors.

ISDN

YES

Integrated Services Digital Network.

MODE

Mode of operation.

ISLD

Route uses ISDN Signaling Link in dedicated mode.

ISLD is allowed when ISDN = YES and the ISL package
147 is equipped. ISLD is allowed only on ISA and TIE
trunks.

DCH

xxx

D-channel number, where:
x = 0 – 255 for Large Systems.
x = 0 – 79 for Small Systems.

IFC

SL1

Meridian Customer Defined Network (MCDN) is required
for Small Systems.

ESGF

ESIG interface with GF platform (QSIG).

ISGF

ISIG interface with GF platform (QSIG).

The IFC of the Route Data Block must match the IFC of
the ISL D-channel in the configuration record.

PNI

(0)–32700

Private Network Identifier. Configure the PNI to 1 or
another non zero value to support MCDN features that
use non-call-associated signaling, such as Network
Ring Again (NRAG), Network Message Services (NMS),
and Network ACD (NACD). Each feature needs ISDN
signaling sent across the Meridian 1/CS 1000M network
in the absence of a call.

The PNI in the Customer Data Block must be the same as
the PNI configured in the Route Data Block at the far end
for outgoing calls from the far end toward this Meridian
1/CS 1000M node.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007