Nortel Networks NN43001-563 - Manual (Page 366)

366 OA and M using the ITG shell CLI and overlays
"Disable an indicated IP trunk card port" (page 362)
"Enable an indicated IP trunk card" (page 362)
"Enable an indicated IP trunk card port" (page 362)
"Display IP trunk card ID information" (page 362)
"Display IP trunk card status" (page 362)
"Display IP trunk card port status" (page 363)
Introduction
This chapter explains how to perform IP Trunk 3.01 (and later) Operation,
Administration, and Maintenance (OA&M) tasks using the ITG shell
Command Line Interface (CLI). The ITG shell can be accessed directly
through a serial port connection, or remotely through Telnet from the TM 3.1
PC or any Telnet client host.
ITG Shell OA and M procedure summary
The following OA&M tasks can be performed from the ITG shell:
• "Change the default ITG shell password to maintain access security"
(page 369)
.
• "Reset the default ITG shell password" (page 370) .
• "Download the ITG operational measurements through the ITG shell"
(page 372)
.
• "Reset the operational measurements" (page 372) .
• "Display the number of DSPs" (page 373) .
• "Display IP Trunk 3.01 (and later) node Properties" (page 373) .
• "Display IP Trunk 3.01 (and later) Gatekeeper status" (page 374)
• "Transfer files through the Command Line Interface" (page 375) .
• "Upgrade IP trunk card software using FTP" (page 377) .
• "Backup and restore from the CLI" (page 380) .
• "Recover the SNMP community names" (page 381)
• "IP Trunk 3.01 (and later) configuration commands" (page 382) .
• "Download the IP Trunk 3.01 (and later) error log" (page 382) .
Access the ITG shell through a maintenance port or Telnet
The ITG shell administration and maintenance commands can be accessed
in two ways:
• Log in through a direct cable connection between the IP trunk card
faceplate maintenance port and a PC.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.