Nortel Networks NN43001-563 User Manual

Page 238

238

Install and configure IP Trunk 3.01 (and later) node

a. If using separate subnets for the voice (TLAN subnet) and

management (ELAN subnet) networks, accept the default setting
Use separate subnets for voice and management check box.

b. If using the same subnet for the voice and management network

(ELAN subnet), uncheck the Use separate subnets for voice
and management check box. The window changes.

If using the default setting Use separate subnets, perform steps a-d.

a. Enter the TLAN node IP address in the Voice LAN Node IP

address field.

b. Enter the ELAN network interface gateway IP address in the

Management LAN gateway IP address field.

c. Enter the ELAN network interface subnet mask in the

Management LAN subnet mask field.

d. Enter the TLAN network interface subnet mask in the Voice LAN

subnet mask fields

The Voice LAN Node IP address on the General tab and the
Voice IP and Voice LAN gateway IP addresses for Leader 0
and Leader 1 on the Card Configuration tab must be on the
same subnet.

If Use separate subnets was unchecked, perform steps a-c as
follows.

a. Enter the ELAN node IP address in the Management LAN

Node IP field.

b. Enter the ELAN network interface gateway IP address in the

Management LAN gateway IP address field. The ELAN
network interface gateway (router) also functions as the voice
gateway (router).

c. Enter the ELAN subnet mask in the Management LAN subnet

mask field.

The Management LAN Node IP and Management gateway
IP addresses on the General tab and the Management IP
for Leader 0, Leader 1 and all Follower cards on the card
Configuration tab must be on the same subnet.

Do not click OK or Apply until the Configuration tab has been
completed.

—End—

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007