Nortel Networks NN43001-563 - Manual (Page 224)

224 Install and configure IP Trunk 3.01 (and later) node
Prompt Response Description
NEDC ETH Near End Disconnect Control from either the originating or
terminating side.
FEDC ETH Far End Disconnect Control from either the originating or
terminating side.
Table 48
LD 16 NEW/CHG/OUT
Prompt Response Description
req new/chg/out
type rdb Route Data Block.
cust 0-99
tktp TIE Trunk Type.
M911P (NO)/YES M911 Trunk Type for MCDN Network.
M911_ABAN (NO)/YES Optional call abandon treatment:
YES = abandoned call treatment for route.
NO = no abandoned call treatment for route.
M911_TONE YES/(NO) optional call abandon tone:
YES = tone given on answer.
NO = silence given on answer.
ABTR (15)
Range 0-30 Timer (in minutes) to block the disconnect from being
tandemed across to the target node. Default value: 15
minutes. This timer value can be added in increments
of 1 minute.
BRIP NO BRIP is set to NO by default, as this is not applicable to
911P routes.
DGTP PRI/PRI2 Valid responses for this prompt are PRI or PRI2 if M911P
prompt is set to YES.
MODE PRA Valid response for this prompt is PRA if M911P if prompt
is set to YES, and VTRK is set to NO.
IFC SL1 IFC is set to SL1 by default if M911P is set to YES. This
prompt is not configurable.
Table 49
LD 16 NEW/CHG/OUT for VTRK
Prompt Response Description
req new/chg/out
type rdb Route data block.
cust 0-99
tktp TIE Trunk type.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.