beautypg.com

Yaskawa L1000E AC Drive CIMR-LE†A User Manual

Page 89

background image

4 Start-Up Programming

YASKAWA TOEPYAIL1E01A YASKAWA AC Drive L1000E Quick Start Guide

89

St

ar

t-

Up

Pr

og

ra

m

m

in

g

4

S1-06: Brake Release Delay Time

Determines the time that must pass after an Up/Down command is entered before the output terminal set for "Brake
control" (H2-

= 50) is triggered.

Adjusting this delay time can help when there is not enough time to develop the appropriate amount of motor flux. Be
sure to also increase the time S1-04 when setting S1-06 to relatively long delay time.

S1-07: Brake Close Delay Time

Determines the time that must pass after zero speed is reached before the output terminal set for "Brake control"
(H2-

= 50) is released.

S1-10: Run Command Delay Time

Sets the time the drive waits after receiving an Up/Down command before starting operation. The time set should give the
motor contactor enough time to close.

S1-11: Output Contactor Open Delay Time

Determines the time that must pass for an output terminal set for “Output contactor control” (H2-

= 51) to be released

after the drive has stopped and drive output has been shut off.

S1-12: Motor Contactor Control During Auto-Tuning Selection

Determines the state of the output contactor control command (H2-

= 51) during Auto-Tuning. The contactor closes

as soon as the Enter key is pressed in the Auto-Tuning start menu.

Setting 0: Disabled
Setting 1: Enabled
Setting 2: Enabled during Auto-Tuning and HBB

WARNING! Sudden Movement Hazard. Use parameter S1-12 to enable/disable automatic switching of the Motor Contactor Control

output signal during Auto-Tuning. When using setting S1-12 = 1 or 2, ensure that the multi-function output terminals are properly wired

and in the correct state before setting parameter S1-12. Failure to comply could result in damage to the drive, serious injury or death.

No.

Parameter Name

Setting Range

Default

S1-06

Brake Release Delay Time

0.00 to 10.00 s

0.20 s

No.

Parameter Name

Setting Range

Default

S1-07

Brake Close Delay Time

0.00 to [S1-05]

0.10 s

No.

Parameter Name

Setting Range

Default

S1-10

Run Command Delay Time

0.00 to 1.00 s

0.10 s

No.

Parameter Name

Setting Range

Default

S1-11

Output Contactor Open Delay Time

0.00 to 1.00 s

0.10 s

No.

Parameter Name

Setting Range

Default

S1-12

Motor Contactor Control during Auto-Tuning

0 to 2

0