Yaskawa L1000E AC Drive CIMR-LE†A - Manual (Page 117)

4 Start-Up Programming
YASKAWA TOEPYAIL1E01A YASKAWA AC Drive L1000E Quick Start Guide 117
St
ar
t-
Up
Pr
og
ra
m
m
in
g
4
Connecting the Drive and Battery
Use the 1.1 m cable packaged with the drive to connect the battery. Remove the connector covering port CN19 before
connecting the cable to CN19.
Information on battery power ratings can be found in Table 30 .
Note: The connector port location and angle vary by drive model.
DANGER! Switch off the power supply before wiring and connecting the battery cable. Failure to comply will lead to death or serious
injury from electric shock.
Battery Connections for CIMR-LE2A0018 to 2A0094 and CIMR-LE4A0009 to 4A0049
1. Insert the tip of a screwdriver into the opening on the edge of the CN19 connector cover. Slide the cover off the
drive as indicated in
Figure 66 .
NOTICE: A straight-edge screwdriver should be inserted into the opening provided on the connector cover at the proper angle.
Attempting to insert the screwdriver blade at a different angle could damage the drive.
Figure 59
Figure 66 Removing the Connector Cover
2. Connect the cable provided to the CN19 port.
NOTICE: Be sure that the connector fastens at the correct angle to the drive port. The incorrect angle could damage the battery, cable,
or connector.
Figure 60
Figure 67 Connecting the Cable
Press inwards on the tab and
slide the connector cover in the
direction indicated by the arrow.
Press in on the connector
clip to plug in the cable.
Port CN19