Terminal cover, Removing/reattaching the terminal cover, Yea_common – Yaskawa L1000E AC Drive CIMR-LEA User Manual
Page 27
3 Electrical Installation
YASKAWA TOEPYAIL1E01A YASKAWA AC Drive L1000E Quick Start Guide
27
El
ec
tr
ical
I
n
st
al
la
ti
o
n
3
◆ Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
■
Removing/Reattaching the Terminal Cover
Removing the Terminal Cover
Models 2A0018 to 2A0094 and 4A0009 to 4A0049
1.
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 10
Figure 10 Removing the Terminal Cover
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.
Figure 11
Figure 11 Removing the Terminal Cover
Models 2A0106 to 2A0432 and 4A0056 to 4A0260
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models.
Figure 12
Figure 12 Removing the Terminal Cover
YEA_common
YEA_common
YEA_common