Yaskawa L1000E AC Drive CIMR-LE†A - Manual (Page 55)

4 Start-Up Programming
YASKAWA TOEPYAIL1E01A YASKAWA AC Drive L1000E Quick Start Guide 55
St
ar
t-
Up
Pr
og
ra
m
m
in
g
4
■ Powering Up the Drive and Operation Status Display
Powering Up the Drive
Perform the following power-off checks before applying main power to the drive.
WARNING! Electrical Shock Hazard. Do not contact live electrical parts. Failure to comply could result in death or serious injury. Never
touch the output terminals directly with your hands or allow the output lines to come into contact with the drive case.
WARNING! Sudden Movement Hazard. Operating a drive with untested emergency circuits could result in death or serious injury.
Always check the operation of drive fast stop circuits and any additional emergency circuits after they are wired. Fast stop circuits are
required to provide safe and quick shutdown of the drive.
WARNING! Sudden Movement Hazard. Ensure start/stop and safety circuits are wired properly and in the correct state before
energizing the drive. Failure to comply could result in death or serious injury from moving equipment.
Status Display
When the power supply to the drive is turned on, the digital operator lights will appear as follows:
9
Function Key 2
(F2)
FWD/REV
Pressing switches between Up and Down when the Up/Down command is set from
the digital operator.
DATA Pressing scrolls to the next display.
→
Pressing scrolls the cursor to the right.
RESET Pressing resets the existing drive fault or error.
<1> Displayed when in Drive Mode.
<2> Displayed when in Drive Mode and Monitor Mode.
Power-off Checks Description
Power supply voltage
Ensure the power supply voltage is correct on the supply side of the disconnect, before applying power to the
drive.
200 V class: 3-phase 200 to 240 Vac 50/60 Hz
400 V class: 3-phase 380 to 480 Vac 50/60 Hz
Properly wire the power supply input terminals (R/L1, S/L2, T/L3). Check for correct wiring, terminals are
tightened, and there are no loose wire strands.
Check for proper grounding of drive and motor.
Drive output terminals and
motor terminals Properly wire drive output terminals U/T1, V/T2, and W/T3 with motor terminals U/T1, V/T2, and W/T3.
Check for correct wiring, terminals are tightened, and there are no loose wire strands.
Control circuit terminals
Check control circuit terminal connections. Check that control circuit terminals are correctly wired, terminals
are tightened, and there are no loose wire strands.
Drive control terminal status Open all control circuits to the drive I/O terminal block.
No. Name Description
Normal
Operation
The data display area in the upper half of the display, displays the speed reference. DRV
is displayed.
Fault
External fault (example)
Data displayed varies by the type of fault. Refer to Fault Displays, Causes, and
Possible Solutions on page 130 for more information and possible solutions. ALM
LED is lit and DRV displayed.
No. Name Display Content
F1
F1
F1
F1
DIGITAL OPERATOR JVOP-180 ALM
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
FWD
RSEQ
LREF
YEA_
c o m -
DIGITAL OPERATOR JVOP-180 ALM
- MODE -
EF3
Ext Fault S3
DRV
FWD RESET
YEA_
c o m -