beautypg.com

Yaskawa L1000E AC Drive CIMR-LE†A User Manual

Page 106

background image

4 Start-Up Programming

106

YASKAWA TOEPYAIL1E01A YASKAWA AC Drive L1000E Quick Start Guide

Parameter Setup

Adjust drive parameters as described below when using Rescue Operation.

• Select the type of Rescue Operation power supply for the drives main circuit in parameter S4-06.
• When using a UPS, set the UPS power value to parameter S4-07. Use parameter S4-08 to decide if the Rescue

Operation speed shall be limited automatically depending on the UPS power.

• If deterioration of the battery or UPS shall be detected, also set up parameters S4-12 and S4-13. Measure the DC bus

voltage during operation using the rescue power supply and set the measured value to parameter S4-12. Set the
deterioration detection level to parameter S4-13.

• Set parameters S4-01 to S4-04 if light load direction search shall be automatically performed when Rescue Operation is

started.

Wiring Examples

Switching the main power supply to a battery or UPS requires magnetic contactors that must be controlled by an external
controller. Wiring methods and the sequence used for the magnetic contactors depend on the application. This instruction
manual describes the following configurations:

• A single-phase, 230 V UPS is used as backup power supply for a 200 V or 400 V class drive.
• Two separate batteries for the main power and control power supplies. Main power battery voltage is below 250 Vdc for

200 V class drives or 500 Vdc for 400 V class drives.

• Two separate batteries. One is used for the main power supply, a second battery supplies the controller via an optional

24 V Backup Power Supply Unit.

• A single battery with minimum 250 Vdc for 200 V class drives or 500 Vdc for 400 V class drives is used for the main

and control power supply.

Select the configuration that matches your application. Follow the corresponding instructions for wiring and drive
settings. For configurations not covered in the list above, contact your Yaskawa representative or our sales office directly
for consultation.