Grass Valley NV9000-SE v.3.0 - Manual (Page 90)

70 Rev 3.0 • 25 Mar 10
7. Routers
Adding a Router
How to Add a Router Using the ‘Routers’ Table
Using the ‘Routers’ table, router names can be added to the NV9000-SE system, but no router
details.
1 Launch NV9000-SE. (See Launching and Exiting the Application on page 12.)
2 From the Navigation area, select the ‘Views’ pane and then ‘Routers’. The ‘Routers’ table
appears:
Figure 7-6. Routers Table
3 Click
Add Router
. A blank row appears.
4 On the blank row, click in the ‘Name’ column to activate it and enter a name for the new router.
5 On the same row, click in the ‘Host’ column and select a system controller from the drop-down
list.
6 Click
Save
. The router is saved to the system and the next sequential identification number
assigned.
7 The router is added without defining details, such as physical levels. To add details, locate the
router and perform steps 5 through 10 as described in How to Add a Router Using the ‘Add
Router’ Wizard or ‘Routers’ Page on page 64. (See How to Locate and View Existing Router
Using the ‘Routers’ Page on page 71.)
8 Click
X
on the window title tab to close the table.