Grass Valley NV9000-SE v.3.0 - Manual (Page 306)

286 Rev 3.0 • 25 Mar 10
11. Control Panels
Adding a Control Panel
b Click a button in the control panel image to select a destination number. The ‘Salvo Display
Entry’ dialog box appears, as shown in Figure 11-23. The text is a toggle.
Figure 11-23. Salvo Display Entry Dialog Box
c Choose a salvo from the drop-down menu and click OK . The salvo number displays on the
selected line in the control panel window.
Or
Click
Delete Entry
to delete the entry.
7 Click
Save
.
Or
To revert to the previously saved configuration, click
Revert to Saved .
8 Click
X
on the window title tab to close the page.
NV9609
The ‘NV9609’ page determines how the NV9609 control panel functions and displays. For a full
description of the control panel and functions, see
NV9609 on page 531.
The ‘NV9609’ page is divided into sections:
• Button Layout — A graphic representation of the buttons on the control panel. Click on a button
to assign a function to it. Certain buttons have preassigned functions and cannot be changed.
• Button Definitions — Assigns a function to the currently selected button in the ‘Button Layout’
field. The options available as definitions change depending on the options selected in the
‘Panel Options’ section.
• Outputs — The general-purpose I/O (GPIO) output connections at the rear of the control panel.
• Inputs — The general-purpose I/O (GPIO) input connections at the rear of the control panel.
• Panel Options — Specifies control panel behavior, such as the default mode.
The control panel options, button layout and button definitions are configured using the ‘NV9609’
page. When saved, the configurations are communicated to the physical control panel and appear to
the operator using the control panel.
Tip Operators using the control panel may define a local salvo by placing the
control panel in “record” mode (using the menu), performing a sequence of
operations, and saving the salvo by giving it a name. The operator must
also add the new salvo to the salvo list so that it can be selected when the
operator places the control panel in salvo mode.