Grass Valley NV9000-SE v.3.0 - Manual (Page 265)

NV9000-SE Utilities • User’s Guide 245
11. Control Panels
Adding a Control Panel
3 In the ‘Panel Options’ section, check a check box to select additional control panel behaviors
(un-check a check box to deselect an option).
Check box Description Related Topic
User
Programmable ID When checked, the Panel ID can be changed locally at the
control panel itself.
When unchecked, ID numbers can only be changed by first
entering the system PIN locally at the control surface to
temporarily enable ID changes.
Changing a Control
Panel ID
on page
351
Save Preset
Default
Makes any Save Preset button active when the control panel
reverts to its default state (after a Default State button is
pressed, or when the control panel is restarted). This button
causes the control panel to save whatever source is in the
‘Preset’ column, so that if the control panel is reset, that
source reappears. When off, the presets are not saved.
Note: If this option is selected, it is recommended that a Save
Preset button be placed on the control panel.
Default State on
page 360
Hold Preset
Default Makes any Hold button active when the control panel reverts
to its default state (after a Default State button is pressed, or
when the control panel is restarted).
Note: If this option is selected, it is recommended that a Hold
button be placed on the control panel.
Hold on page 361
Default State on
page 360
Enable Source
Lock Enables any Lock button to lock sources on the control panel.
If ‘Enable Source Lock’ is unchecked, the Lock button
cannot be used to lock sources on the control panel. Locks on page 362
Enable Source
Protect Enables any Protect button to protect sources on the control
panel. If ‘Enable Source Protect’ is unchecked, the Protect
button cannot be used to protect sources on the control panel. Protect on page 363
Enable
Destination Lock Enables any Destination Lock button to function. If ‘Enable
Destination Lock’ is unchecked, the Destination Lock button
will not function on the control panel. Locks on page 362
Enable
Destination
Protect Enables any Destination Protect button to function. If
‘Enable Destination Protect’ is unchecked, the Destination
Protect button will not function on the control panel. Protect on page 363
Source Master
Default Makes the source the controlling (or “master”) device
permanently. By default, ‘destination is master’ is selected.
(This option is specifically for use with a Miranda data router
or port switch.)
“Source is master” is used for duplication, or broadcast
routing, on the control level. “Destination is master” is for
machine-to-machine editing.
Note: “Source is master” mode reverses the direction of data
routing for devices used in data (control) level "takes".
Note: If ‘Source Master Default’ is selected, the Source
Master button will not switch to “destination is master” mode
when pressed.
Source Master on
page 365
Hide sources not
configured on this
panel Hides name of all source devices that are not presently
configured. The control panel displays asterisks instead. —