Grass Valley NV9000-SE v.3.0 - Manual (Page 390)

370 Rev 3.0 • 25 Mar 10
12. Master Control
Locating and Viewing Master Controls
Locating and Viewing Master Controls
Depending on the information you want to view, different interfaces present different master con-
trol information:
• ‘Routers’ page (accessed through the ‘Configuration’ pane) — A list of existing routers, includ-
ing master control processors. Opens the ‘Master Control Details’ page which displays details
for an individual, selected master control processor.
• ‘Routers’ table (accessed through the ‘Views’ pane) — A list of all existing routers, one per row,
including master control processors, with name and host.
• ‘Router Control’ table (accessed through the ‘Views’ pane) — A list of existing routers, includ-
ing master control processors, and associated control point, one control point per row.
How to Locate and View Existing Master Control Processors
Use the ‘Routers’ page.
1 Launch NV9000-SE. (See Launching and Exiting the Application on page 12.)
2 From the navigation area, select the ‘Configuration’ pane and then ‘Routers’. The ‘Routers’
page displays, as shown in Figure 12-3. All routers and master control processors currently
defined in the system are listed.
To narrow the list, enter the first few characters of the master control processor’s name in the
‘Router Filter’ field. The list is automatically reduced to display only master control processors
matching that character string.
Or