Guralp Systems CMG-DCM build <10,000 - Manual (Page 20)

CMG-EAM (Platinum Firmware)
Once the IP address of the CMG-EAM has been set or determined, you
can connect to its web-server. Simply type http:// followed by the IP
address of the unit into your web browser's address bar (e.g.
http://192.168.0.1 ). You should be prompted for a user-name
and password. The user-name is root and the initial password, as
shipped, is rootme (the same as on the command line).
If you are connecting to the CMG-EAM over a network that you
consider insecure, it is recommended that you use the HTTPS (secure
HTTP) protocol, which uses TLS to encrypt the link. Simply change
the http:// prefix to https:// in the browser's address bar. Most
browsers will complain that the certificate cannot be verified: This is
not a problem: simply press the “accept” button to proceed. The link
will then be encrypted and nobody will be able to “sniff the wire” in
an attempt to discover passwords and other data.
Once connected and logged in, you will be presented with the main
summary screen. This contains general information about the status
and health of the CMG-EAM:
The exact contents and layout of this screen will vary depending on
the configuration of both the EAM and of any attached hardware.
20 Issue C