Guralp Systems CMG-DCM build <10,000 - Manual (Page 156)

CMG-EAM (Platinum Firmware)
To configure the transmitter, click on the link corresponding to the
required instance. You will see the following screen (only the top part
of which is shown here):
The description of the instance can be changed if desired. This may
be useful if you have multiple instances. This description is seen
when viewing running services or configuring instances. It is not seen
by the clients.
Subsequent instances can be enabled or disabled with a check-box but
this is absent from the page for the default instance because the default
instance is always enabled.
The instance name, as seen by the client, can be set in the first field
under “Network settings”. A suitable default is used if this field is left
blank.
If the CMG-EAM has multiple network addresses, it can be restricted
to listen for incoming connections on only one of them by entering its
address here. If left blank, the transmitter will listen on all available
instances.
The default service (port) for the transmitter is 1565 but an alternative
port can be entered here if required.
Backfill is the process whereby missing data is recovered. It can be
156 Issue C