Guralp Systems CMG-DCM build <10,000 - Manual (Page 180)

CMG-EAM (Platinum Firmware)
•
adc­command module obs­centre
Centre each of the masses for deployment of an OBS system.
This sub-command takes no options.
•
adc­command module obs­align bowl=which
Align the levelling bowl of an OBS system. The parameter
which should be one of 1BOWL (for single-bowl units), Z, N/S
or E/W.
•
adc­command module obs­recover
Prepare anOBS system for recovery by locking the masses
and returning the bowl leveller to its datum position. This
sub-command takes no options.
The CMG-EAM also provides the ability to connect to the terminal of
any connected Güralp digitisers in order to configure their operation
and control the attached sensors. To do this, connect to the CMG-EAM
terminal as in section 2.1 or 2.2 and run the “data-terminal” command.
eam999 ~ # data-terminal
Select the desired digitiser (using the up/down arrow keys and Enter to
select) from the list that is presented:
This will launch a minicom session (see section 14.4), allowing you to
communicate with the digitiser terminal. For example:
Welcome to minicom 2.3-rc1
OPTIONS:
Compiled on Feb 9 2008, 16:59:26.
Port /dev/tts/0
Press CTRL-A Z for help on special keys
LW B68000 CMG-5TD Command Mode
0 blocks in buffer | 256 blocks free
Guralp Systems Ltd - DM+FW v.103 mgs 13/02/08 (Build 65)
CTRL-A Z for help |115200 8N1 | NOR | Minicom 2.3-rc | VT102 | Offline
180 Issue C