Guralp Systems CMG-DCM build <10,000 - Manual (Page 148)

CMG-EAM (Platinum Firmware)
The Log level drop-down menu controls the level of detail present in
log messages, whether to syslog or to a dedicated log file. Not all of the
standard syslog logging levels are available. The menu offers a choice
(in order of decreasing detail) of:
•
Debugging information;
•
Informational messages;
•
Important notices; or
•
Warnings
In most configurations, all data for all transmitters is taken from a
single multiplexor, as described in section 1.3 on page 10. For more
complex configurations, it is possible to configure multiple
multiplexers, each with their own set of input and output services. In
these situations, the GDI multiplexer drop-down menu can be used to
select a multiplexer instance with which to associate this transmitter.
The menu offers a list of currently configured multiplexers.
11.5 Quick Seismic Characteristic Data
QSCD is a protocol developed by KIGAM ( http://www.kigam.re.kr/eng )
to send strong motion results, which are computed every second.
To set up a QSCD server on the CMG-EAM, first configure the relevant
strong motion data sources as described in section 7 on page 78, then,
from the web interface, select “System services” from the
“Configuration” → “All options” menu or select the “Services” short-
cut from the “Data transfer/recording” menu. To configure a QSCD
server from the command line, start gconfig and select “System
services” from the top level menu.
Now select “qscd-out -- KIGAM QSCD (Quick Seismic Characteristic
Data) sender ” from the System Services menu. The next screen shows
a list of all QSCD server instances that have been configured:
148 Issue C