Comtech EF Data CDM-760 - Manual (Page 75)

Updating Firmware Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
4–9
b) Use Command-line:
• Type “cd C:\CDM760” at the Command-line prompt to change to the temporary
directory created earlier using Command-line.
• Type “dir” to list the files extracted to the temporary directory from the
downloaded archive file.
You have downloaded your firmware files successfully they are now available for transfer to
the CDM-760.
4.4 Perform the Ethernet FTP Upload Procedure
4.4.1 Prerequisites
If you proceed with the CDM-760 Ethernet FTP Upload Procedure, this section
assumes that:
• Your CDM-760 is connected to a user-supplied, Windows-based PC running the
latest version of Java, and:
o
The PC Ethernet port is connected to the CDM-760 rear panel J4 | MGMT
RJ-45 port (alternately, if the optional High-Speed Packet Processor is
installed and enabled, the P0 | MGMT RJ-45 port) with a user-supplied hub,
switch, or direct Ethernet cable connection.
o
The PC is running a compatible Web browser (for operation of the HTTP
Interface).
o
The PC serial port is connected to the CDM-760 rear panel J3 | REMOTE
serial port with a standard user serial cable.
o
The PC is running a terminal emulation program (for operation of the
CDM-760 Serial Remote Control Interface).
• You have noted the CDM-760 Ethernet Management IP Address using either
the CDM-760 Front Panel or the Serial Remote Control Interface. You may also
use the HTTP Interface Admin | Access page to review and reconfigure this IP
Address as needed.
• You have downloaded (or otherwise received from Comtech EF Data) the latest
available firmware update, and you have extracted the firmware files into an
accessible temporary folder (e.g., C:\CDM760) on the User PC.
• You have configured modem remote control for “Ethernet” or “Ser+Ethernet” –
confirm by viewing the Front Panel SELECT: Configuration → Remote screen: