Comtech EF Data CDM-760 - Manual (Page 213)

Ethernet-based Remote Product Management Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–55
7.4.4.4.6 Status | Traffic Statistics Pages
Except where noted, these nested pages are accessible only to Admin users when
the optional High-Speed Packet Processor card is installed and enabled. See Sect.
7.4.3.1 for information about using conditional access pages.
The read-only Traffic Statistics pages update automatically every 10 seconds. Click the Traffic
Statistics primary page tab, and then select the Ethernet, MAC Table, Packet Flows, Router,
Bridge, WAN, Header Comp, Payld Comp, QoS, or Clear Counters tab to continue.
7.4.4.4.6.1 Status | Traffic Statistics | Ethernet
This page is available with or without the presence of the optional High-Speed Packet Processor:
• When the Packet Processor is either not installed or installed but disabled (Figure 7-31) this
page reports the traffic statistics for the J4 |MGMT, J5 | DATA, J6 | DATA, and J7 | OPTICAL
Ethernet ports.
• When the Packet Processor is installed and enabled (Figure 7-32) this page reports the
traffic statistics for the Packet Processor’s P0 | MGMT, P1 | DATA, P2 | DATA, P3 | DATA,
and P4 | DATA Ethernet ports.
Figure 7-31. Status | Traffic Statistics | Ethernet Page (Packet Processor
DISABLED or NOT INSTALLED)
Click [Clear IP Statistics] to clear/reset the Ethernet statistics buffers.