Comtech EF Data CDM-760 - Manual (Page 182)

Ethernet-based Remote Product Management Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–24
1) All ports are auto-crossover/auto-sensing.
2) It is critical that your port settings match the settings of the connected
equipment. A mismatch of port settings can cause random packet loss and
connection drops.
7.4.4.3.2.2 Configuration | Interface | PIIC
This page requires installed optional Plug-In Interface Card(s). PIICs are not
available when the optional High-Speed Packet Processor is installed; for such
applications, this page is non-functional and the message PIIC Not Installed”
displays in the Slot 1 and Slot 2 page sections.
Use this page to configure the optional G.703 E3/T3/STS-1, OC-3 Single / Multi Mode, and STM-1
Copper PIIC modules, if installed, in PIIC Slots 1 and/or 2.
(TOP) Page Appearance w/Functional PIICs Installed
(BOTTOM) Page Appearance w/Optional High-Speed Packet Processor Installed (PIIC
Operation Non-Functional, Banner and Menus not shown)
Figure 7-10. Configuration | Interface | PIIC Page