Comtech EF Data CDM-760 - Manual (Page 291)

Appendix A Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
A–13
• For a soft reboot – From the Firmware Image Config section of the CDM-760 HTTP
Interface Configuration | Utilities page, click [Reboot Modem]:
Note that, if booting into a new image and the Top Card Application has been changed, an
additional step occurs as the CDM-760 downloads to a different flash memory. This
additional upload takes approximately two minutes.
Once the modem reboots, you will be prompted to re-enter the User Name and Password in
order to resume use of the CDM-760 HTTP Interface.
10. Use one of these methods to verify that the PC-to-Modem FTP file transfer was successful:
• From the CDM-760 Front Panel – Confirm that, upon reboot, the modem Firmware
Version that displays on the CDM-760 Front Panel VFD top-level screen matches the
firmware version just loaded. You may also review the SELECT: Utility → Firmware →
Info → Image#1 and Image#2 screens for detailed firmware information.
• From the CDM-760 HTTP Interface – Review the firmware version on the Home page, or
the Image 1 and Image 2 folder contents on the Status | Firmware page:
(Note that the appearance of the CDM-760 HTTP Interface Status | Firmware FW Ver.
1.1.1 page differs from the appearance of the FW Ver. 1.4.1 page. The FW Ver. 1.1.1
page is shown here.)
• Using the Serial Remote Control Interface – Execute one of these remote control
queries:
o
Condensed – <0/SWR? (displays firmware versions)
o
Detailed – <0/FRW?1 (for Image 1) or <0/FRW?2 (for Image 2) (displays complete
firmware load information)
11. To update the other firmware image, repeat Steps 3 through 10.
The CDM-760 is now operating with its upgraded firmware. The firmware update process is
now complete.