Comtech EF Data CDM-760 - Manual (Page 289)

Appendix A Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
A–11
The “Remote site:” pane
(on the right-hand side,
representing the CDM-
760) should look like this:
3. On the CDM-760 Front Panel – Go to the SELECT: Utility → Firmware screen and make note
of the displayed ActiveImage:
Firmware Images: ActiveImage: 2
Info Select ( )
Alternately, from the Firmware Image Config section on the CDM-760 HTTP Interface
Configuration | Utilities page, note the current Active Image:
If the screen displays “1” then the modem is currently running out of IMAGE1 and you must
update IMAGE2. If the screen displays “2” then you must update IMAGE1.
4. From the FileZilla “Remote site:” pane – Once you determine which image to update,
double click on the “IMAGE1” or “IMAGE2” folder. (Because ActiveImage = 2 in this
example, select the “IMAGE1” folder.)
5. From the FileZilla “Local site:” pane – Click on the “C:\CDM760\IMAGEx” folder. The folder
contents will display in the bottom section of the pane.
6. Highlight the
“C:\CDM760\IMAGEx”
folder contents in the
bottom section of the
“Local site:” pane. Then,
drag and drop the
contents into the bottom
section of the “Remote
site:” pane: