beautypg.com

Comtech EF Data CDM-760 User Manual

Page 180

background image

Ethernet-based Remote Product Management

Revision 2

CDM-760 Advanced High-Speed Trunking Modem

MN-CDM760

7–22

Absent the optional High-Speed Packet Processor, the rear panel GBEI 1 (J5 | DATA), GBEI 2 (J6

| DATA) ports and the optional Optical Ethernet SFP Module (J7 | OPTICAL) are operational and

configurable.

Note the following:

GBEI Common

Use the drop-down lists to select Flow Control or Learning as Enabled or Disabled.

Click [Submit] to save.

G B E I Interfaces (Dis able P IIC Interfaces B efore C onfiguring E thernet P orts )

Use the drop-down lists to select the appropriate mode of operation for the GBEI 1 (J5 | DATA),

GBEI 2 (J6 | DATA) ports or, when installed, the optional Optical Ethernet SFP Module (J7 |

OPTICAL).

Click [Submit] to save.

Tx Data Rates (read-only)

See Chapter 6. FRONT PANEL OPERATION Sect. 6.2.2.2. (CONFIG: Tx) DataTx Data

Rate for detailed information about calculated data rates.

Ethernet Data Rate (ETH_DR) – This is always TOT_DR – MIN_DR. It is all data associated

with the Ethernet data interfaces.

Minimum Data Rate (MIN_DR) – This read-only value is always zero (000000.000) when the

unit is in Single Stream Mode and only Ethernet Data Type is enabled.

If the minimum data rate is not zero, then the modem is in MultiStream Mode. In

MultiStream Mode, the MIN_DR is the aggregate of all active non-Ethernet interfaces, plus

the MultiStream overhead. This overhead is 1.5% of the aggregate non-Ethernet data in

Normal Block Mode, and 5% in Short Block Mode.

Total Data Rate (TOT_DR) – This read-only value is the aggregate data rate of the modem.

It relates to the Tx symbol rate and spectral efficiency (ModCod) settings

.

Interfaces (read-only)

This section displays the operating status for all Ethernet and PIIC interfaces. Multi-stream Mode

operation is also identified here as Enabled or Disabled.

Otherwise, when the optional High-Speed Packet Processor is installed and enabled, note the

following:

Network Configuration

Enter a valid Mgmt IP Address/Mask for the P0 | MGMT port, subject to the following

restrictions: