3 (config: rx) freq (frequency) – Comtech EF Data CDM-760 User Manual
Page 110

Front Panel Operation
Revision 2
CDM-760 Advanced High-Speed Trunking Modem
MN-CDM760
6–24
After the receive path is locked, the Rx menus show the applicable data rate, modulation type,
code rate, pilots ON/OFF, FEC frame length spectral inversion, etc.
6.2.2.3.3 (CONFIG: Rx) Freq (Frequency)
Freq:1200.0000 MHz Spectrum:Normal
Rxα:.20 GoldCode:000000
()
The Spectrum Inversion status is read-only. The active status displays as either Normal or
Inverted.
The active Rxα (Rx Alpha Filter Rolloff Factor) status is read-only. The displayed value depends on
the active network specification:
Network Specification Rxα (Rx Alpha Filter Rolloff Factor) (%)
DVB-S2
.20, .25, .35
DVB-S2-EB1
.05, .10, .15, .20, .25, .35
Demodulator Unlocked N/A
Otherwise, use the arrow keys to select a parameter. Press ENTER.
(CONFIG: Rx) Freq Freq
Use the arrow keys to select a digit, and then use the arrow keys to change that digit.
Press ENTER.
(CONFIG: Rx) Freq GoldCode (Gold-n Index Code)
CRITICAL – Make sure that the Rx GoldCode value matches the Tx GoldCode value
of the distant end modem.
The GoldCode indicates the Physical Layer spreading sequence number. Use the arrow keys
to select a digit, and then use the arrow keys to change that digit. Press ENTER. Valid
settings are:
Minimum
Maximum
Default
000000
262141
000000