Comtech EF Data CDM-760 - Manual (Page 112)

Front Panel Operation Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
6–26
Table 6-5. Config: Intf Screen
Interface (Top line)
Indication
(Bottom Line) Description
Gigabit Ethernet:
GBEI1 port
(J5 | DATA)
and
GBEI2 port
(J6 | DATA)
(Inoperable when
the optional Packet
Processor is
ENABLED)
Off
The GbE interface is Off. The PHY is down. The interface is in Tri-state
mode and all LED indicators are non-functioning.
Auto
The GbE interface is On. The PHY is up. Both the port speed and Full/Half
Duplex communications are auto-negotiated.
10/H
The GbE interface is On. The PHY is up. The port speed is 10 Base-T with
Half Duplex communications.
10/F
The GbE interface is On. The PHY is up. The port speed is 10 Base-T with
Full Duplex communications.
100/H
The GbE interface is On. The PHY is up. The port speed is 100 Base-T
with Half Duplex communications.
100/F
The GbE interface is On. The PHY is up. The port speed is 100 Base-T
with Full Duplex communications.
1000/F
The GbE interface is On. The PHY is up. The port speed is 1000 Base-T
with Full Duplex communications.
Optional Optical
Ethernet port
(J7 | OPTICAL)
NONE
The interface is either disabled via FAST Option or there is no SFP
module present.
Off
The interface is enabled via FAST Option, and the SFP is present but it is
not in use.
On
The interface is enabled via FAST Option and in use, and the SFP is
present. All communications via this port is 1000 Base-T (GbE), auto-
negotiating only.
Optional Plug-In
Interface Card
Slots: PIIC1 (Slot1)
and PIIC2 (Slot 2)
(Not available when
the optional Packet
Processor is
INSTALLED)
NONE No PIIC module is physically installed in the slot.
XXXX-Off
Example: OC3-Off means that an OC-3 PIIC module is installed in the
slot but it is not being used.
XXXX-YY
Example: G703-E3 means that a G.703 E3/T3/STS-1 PIIC module is
installed and is active with a selected data type of E3 (valid selections are
E3, T3 and S1 (STS-1)).
Optional High-
Speed Packet
Processor
Disabled
The optional Packet Processor is installed but not yet active (enabled for
operation).
Enabled The optional Packet Processor is enabled for operation.