Comtech EF Data CDM-760 - Manual (Page 138)

Front Panel Operation Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
6–52
• The Delay in a properly working CnC link is typically between 230 ms and 290 ms. Delay
when bench-testing CnC operation is typically less than 100 µs.
6.2.3.6 (Monitor:) Stats (Statistics)
Statistics are reported for base unit operation only. M&C for the High-Speed Packet
Processor is provided on the CDM-760 HTTP Interface. See Chapter 7. ETHERNET-
BASED REMOTE PRODUCT MANAGEMENT for full information about using this
interface for Packet Processor operations.
IP BasebandFraming Compression
()
Use the   arrow keys to select IP, BasebandFraming, or Compression. Press ENTER.
6.2.3.6.1 (Monitor: Stats) IP
IPstats: WAN Total Last10s ()
Bytes to WAN 0.0E+00 0.0E+00 Clr:N
An example of an IP statistics screen is shown here. Use the   arrow keys on the top line to
select the IPstats port selection; then, on the bottom line, select the port-specific operational
statistics or the Clr: option.
(Monitor: Stats) IP  View Statistics
First, on the top line – Use the  arrow keys to select the IPstats: port:
IPstats Port Selection Ref Rear Panel Connector
GigE 1 J5 | DATA port
GigE 2 J6 | DATA port
WAN N/A
M&C J4 | MGMT M&C 10/100 port
Opt J7 | OPTICAL port
Next, on the bottom line – Use the  arrow keys to browse the available IPstats (operational
statistics) for the selected port:
Port Selection (top line) Statistic
(bottom line)
Description
GigE1 GigE2 WAN M&C Opt
X X X Packets from LAN Number of acceptable Ethernet Packets received on
selected port from the LAN
X X X Packets to LAN Number of Ethernet Packets sent to LAN from selected
port
X X X Bytes from LAN Number of acceptable Bytes received on selected port
from LAN