Comtech EF Data CDM-760 - Manual (Page 126)

Front Panel Operation Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
6–40
Use the  arrow keys to set Compression as Enabled or Disabled. Press ENTER.
When Compression is Enabled, ALL traffic on all active ports and all active PIIC interfaces will be
routed through the compression card and will be compressed. The Tx side of the modem will be
symbol rate-limited by the lesser of the FAST-activated Tx or Tx compression symbol rate. All
other FAST Options (e.g., CnC data rate) will still apply.
6.2.2.6.2 (CONFIG: Comp) Decompression
Decompression enables or disables the Rx decompression path (Satellite to LAN). Rx
decompression is not a FAST Option, and it does not require activation with a FAST Access Code.
Use the  arrow keys to set Decompression as Enabled or Disabled. Press ENTER.
When Decompression is Enabled, Rx decompression works at all data rates regardless of the
FAST-activated Tx compression. The decompression setting must match the far side CDM-760 Tx
compression setting. A mismatch causes all data to be dropped.
6.2.2.7 CONFIG: Remote
Remote Control=Serial+Ethernet
Inband=Disable
Use the   arrow keys to select Remote Control or InBand. Press ENTER.
6.2.2.7.1 (CONFIG: Remote) Remote Control
Use the  arrow keys to select a parameter. Press ENTER.
(CONFIG: Remote) Remote Control  Local
Select Local to limit monitor and control (M&C) of the unit only to the modem front panel.
Local control (front panel operation) is always available, regardless of which setting is
selected on this menu.
(CONFIG: Remote) Remote Control  Serial or Ser+Ethernet
Interface= RS-485-2W (232,485-2,485-4)
Address= 0001 38400 baud ()
Select Serial to allow EIA-232/485 or Telnet remote access to the modem.
Select Ser+Ethernet (Serial+Ethernet) to allow all methods of remote access to the modem.
Use the   arrow keys to select Interface, Address, or (Baud rate). Press ENTER.