Comtech EF Data CDM-760 - Manual (Page 133)

Front Panel Operation Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
6–47
6.2.2.10.2 (CONFIG: Ref) Internal Ref Fine Adjust
With the Internal 10 MHz Reference selected, very fine adjustment of the Internal 10 MHz
Reference is possible. The adjustment value is retained in EEPROM memory, and is therefore
not lost when the NVRAM is cleared.
Use the   arrow keys to select a digit, and then use the  arrow keys to change that digit.
Press ENTER.
Changes made to the adjustment value take effect immediately, not after the
ENTER key is pressed.
6.2.2.11 CONFIG: MEO (Medium Earth Orbit)
This menu is not available when in Normal (Geostationary) operation (Sect.
6.2.2.1.2 (CONFIG: NetSpec) Operating Mode).
AntId:0 AntStat:0 SatId:None Mute:0
Handover:00
This read-only screen displays information generated by the ACU (Antenna Controller Unit). Press
ENTER or CLEAR to return to the previous menu. Note the following:
Parameter Description
AntId This is the identification number of the antenna that is linked with the modem.
AntSat This is the status of the antenna that is linked with the modem.
SatId This is the identification number of the satellite that is linked with the modem.
Mute This is the status of the BUC that is linked with the modem.
Handover This is the number of seconds remaining in the antenna handover window
6.2.3 SELECT: Monitor
Monitor: Live-Alarms Stored-Events ACM
Rx-Params CnC Stats Buffer MEO ()
Use the   arrow keys to select a parameter. Press ENTER.
6.2.3.1 (Monitor:) Live-Alarms
Live Alarms: Unit Transmit Receive
()
Use the   arrow keys to select as parameter. Press ENTER.