Comtech EF Data CDM-760 - Manual (Page 194)

Ethernet-based Remote Product Management Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–36
Column Description
Weight Enter a weight from 1 to 100. Weighting is used either to drain traffic having the same
Priority Level (“Max/Priority” mode) or to drain after the minimum bandwidth is met
(“Min/Max” mode).
Appendix K. QUALITY OF SERVICE (QoS)
WRED Use the drop-down list to Disable or Enable WRED (Weighted Random Early Detection).
Filter All QoS allows flows to be ‘filtered’ on a per-rule basis so the Packet Processor discards traffic
that you do not want to forward over a satellite link. Use the drop-down list to Disable or
Enable filtering.
For either QoS Mode, click [Add Rule] to execute addition of the new rule to the QoS Rules
Table. Upon entry, the QoS Rules Table index automatically increments to the next available
number.
QoS Rules Table (read-only)
In ‘Max/Priority’ QoS Mode:
In ‘Min/Max’ QoS Mode:
This read-only table displays all existing QoS Rules. Typical for each rule (see “Add New QoS
Rule” for detailed descriptions for each item), from left to right:
Column Description
Index This is the read-only, automatically assigned internal table index number.
Protocol Displays the assigned protocol for the rule.
VLAN Range
Displays the assigned VLAN ID – either a single VLAN ID (2012) or a range of VLAN IDs
(2000-2012).
MPLS EXP
Displays the assigned MPLS (Multi-Protocol Label Switching) experimental bit value (explicit or
wildcard).
TOS Displays the assigned Type of Service bits.
Src IP/Mask Displays the assigned permitted Source IP Address/Mask in the form XXX.XXX.XXX.XXX/YY.
Dst IP/Mask
Displays the assigned permitted Destination IP Address/Mask in the form
XXX.XXX.XXX.XXX/YY.
Min Src Port Displays the assigned minimum permitted Source Port.
Max Src Port Displays the assigned maximum permitted Source Port.
Min Dst Port Displays the assigned minimum permitted Destination Port.
Max Dst Port Displays the assigned maximum permitted Destination Port.
Min BW (Kbps) (“Min/Max” mode only) Displays the assigned minimum permitted Bandwidth value.