Comtech EF Data CDM-760 - Manual (Page 111)

Front Panel Operation Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
6–25
6.2.2.3.4 (CONFIG: Rx) EsNo
Receive EsNo Alarm Point = -03.0 dB
()
Use the   arrow keys to select a digit, and then use the  arrow keys to change that digit.
Press ENTER.
If the Rx Es/No falls below this value and the fault is NOT masked, the modem
generates a receive traffic fault.
6.2.2.4 CONFIG: Intf (Configure Interface)
• Appendix C. OPTIONAL PIIC (PLUG-IN INTERFACE CARD) MODULES
• Appendix F. OPTIONAL HIGH-SPEED PACKET PROCESSOR
1) The acronyms “GbE” and “GigE” both refer to “Gigabit Ethernet.” They are used
interchangeably throughout the front panel interface.
2) The selections here will vary, depending both on the presence of the PIIC or
High-Speed Packet Processor hardware options and whether Single Stream or
MultiStream Operating Mode is in use.
When the PIIC interface slot card is installed:
GBEI1 GBEI2 Optical PIIC1 PIIC2
Auto Off NONE G703-E3 G703-OFF
When the optional High-Speed Packet Processor card is installed:
GBEI1 GBEI2 Optical PacketProcessor
Off Off NONE Enabled
Use this screen to see the installation status and configured state of each interface. This screen
consists of five columns when the standard PIIC slot card is installed or four columns when the
optional High-Speed Packet Processor card is installed.
The top line of each column displays an available interface; the screen shows the installation
and configuration status for that interface directly below.
On the bottom line – Use the   arrow keys to select a configurable interface. Press ENTER.
Table 6-5 provides detailed information for the menu selections and their conditional availability.